Actron scanner 9040 Manual

PDF Manuals
12 Pages English

Actron scanner 9040
©2004 SPX Actron. All Rights Reserved.
Printed in USA
0002-002-2356
REL TPS (0 - 100%)
Relative Throttle Position is relative throttle position at normal position.
SECOND AIR (AIR_STAT: UPS, DNS or OFF)
Commanded Secondary Air Status is on newer vehicles and actuators to control pollution control.
UPS - UP STREAM module is demanding that secondary air be added at
exhaust manifolds
DNS- DOWN STREAM module is demanding secondary air be added at
catalytic converter
OFF - Module is demanding no secondary air to be added.
ST FTRMxy (-100 - 99.22%)
Short-term Fuel Trim Bank calculated value represents the short-term relation of fuel metering on
a fuel-injected engine.
NOTE: Short-term Fuel Trim calculated value that has a positive percentage is a
rich fuel trim and if a negative percentage is present the fuel trim is lean.
ST FLTRMx (-100 - 99.2%)
Short-term Fuel Trim value represents the short-term relation of fuel metering on a fuel-injected
engine.
NOTE: Short-term Fuel Trim value with a positive percentage is a rich fuel trim and
if a negative percentage is present the fuel trim is lean.
THR POS (0 - 100%)
Absolute Throttle Position is the position the throttle is located. The more the throttle is closed the
less percent shown.
THROT CMD (0 - 100%)
Commanded Throttle Actuator Control is the position of the throttle. If throttle is closed the
percent will be 0 and if wide open 100%.
TRIPS SNC CLR (0 - 255)
Number of warm-ups since diagnostic trouble codes cleared. Warm-up is when temperature of
coolant rises to at least 22°C (40°F) from engine starting and reaching a minimum temperature of
70°C (160°F). If a disel engine the engine minimum temperature is 60°C (140°F.)
TROUB CODE (00 00 - FF FF)
Trouble Code Parameter will give the diagnostic trouble code that caused a freeze frame
capture. This information is helpful in diagnosing the cause of a driveability. If no freeze frame
data has been captured this PID will be zero.
VEH SPEED (0 - 255K/h) or (0 - 158mph)
Vehicle Speed shows the speed the vehicle is going.
VPWR (0 - 65.535V)
Control Module Voltage is the power input to the control module.
Related Manuals for Actron scanner 9040