User Manual Lucent Technologies Switch 1100 [60/84 Pages]

Lucent Technologies switch 1100

Installation

Issue 1 June 1998 3-5

Following installation, administer the line and station ports that use

the Switch Module according to the instructions in DEFINITY®

Communications System Generic 3 Implementation Guide, Issue

1, document #555-230-655.

Follow these steps to install the Switch Module:

1. Ensure that the module has the proper DIP switch configuration

(see Table 3-1).

Table 3-1. DIP Switch Configuration

Switch # OFF ON

µ-Law companding

A-Law companding

2 Normal operation Reserved

3 Normal operation Reserved

4 Normal operation Test mode

NOTE:

You should not change the factory-set DP switches; all DIP

switches be set at OFF. Check with your system administrator

before making changes.

CAUTION:

Do not plug the A/C adapters into the electrical outlets until

instructed to do so in the following procedure.