Wayne-Dalton backyard playset 8850 Manual

PDF Manuals
27 Pages English

Wayne-Dalton backyard playset 8850
13
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Tools Needed:
INSTALLATION
9
Step Plate
Position your step plate, on the inside of
the door, over the bottom section end stile
on the side of the door containing the side
lock. Secure step plate to endstile with (2)
5/16” x 1” self drilling screws, as shown.
For doors ordered with non-keyed locks,
a second step plate is provided. Install the
second step plate in the same manner as
the first, on the lock section (second section),
below the side lock.
NOTE: Install lock at this time (sold
separately) see instructions in OPTIONAL
SIDELOCK INSTALLATION on page 22.
NOTE: Install exhaust port at this time (sold
separately) see instructions in OPTIONAL
EXHAUST PORT INSTALLATION on page
24.
END STILE
(2) 5/16” X 1” SELF
DRILLING SCREWS
BOTTOM SECTION
STEP PLATE
LOCK SECTION
IF SECOND STEP PLATE WAS
RECEIVED FOR DOORS ORDERED
WITH NON-KEYED LOCKS, INSTALL
IT BELOW THE SIDE LOCK.
Tools Needed:
10
Top Section
Hammer
Nail
Power Drill
7/16 Socket
Driver
Tape Measure
Place the top section in the opening and
vertically align with lower sections.
Temporarily secure the top section by
driving a nail in the header near the center
of the door and bending it over the top
section.
Now flip up hinge leaf against section,
fastening center hinges first, and end
hinges last. (Refer to Step 5).
When installing a door with a torsion
counterbalance system, vertical track
alignment is critical. Position flagangle
between 1-11/16” (43 mm) to 1-3/4” (44
mm) from the edge of the door. Tighten
the bottom lag screw. Flagangles must be
parallel to the door sections.
Repeat for opposite side.
IMPORTANT: THE DIMENSION BETWEEN
THE FLAGANGLES MUST BE DOOR WIDTH
PLUS 3-3/8” (86MM) TO 3-1/2” (89 MM)
FOR SMOOTH, SAFE DOOR OPERATION.
Complete the vertical track installation by
securing the center jamb bracket(s) and
tightening the other lag screws.
Push the vertical track against the rollers
so that the rollers are touching the
deepest part of the curved side of the
track (see illustration). Tighten all the
carriage bolts and nuts.
Repeat for opposite side.
DOOR WIDTH
+3-3/8” TO 3-1/2”
NAIL
ROLLER
VERTICAL TRACK
ROLLER AGAINST
VERTICAL TRACK
TOP SECTION
TOP
SECTION
1-11/16”
TO
1- 3/4”
FLAGANGLE
TOP
SECTION
Related Manuals for Wayne-Dalton backyard playset 8850