User Manual Wayne-Dalton Backyard Playset 8850 [18/27 Pages]

Wayne-Dalton backyard playset 8850

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com

Tools Needed:

Counterbalance Cables

Vice Grips

3/8” Wrench

Step Ladder

Thread the counterbalance cables around

the back side of the cable drums and verify

that there are no cable obstructions. Hook

the cables into the drums. Slide the left

hand cable drum against the left hand end

bearing bracket and tighten the set screws

in the drum to 14-15 ft. lbs. of torque

(Once set screws contact the tube, tighten

screws one full turn). Rotate the left hand

drum and torsion tube until cable is taut.

Attach vice grips to torsion tube and brace

vice grips against jamb to keep cable taut.

Slide the right hand cable drum against the

right hand end bearing bracket and rotate

drum until cable is taut. Tighten set screws

in right hand cable drum to 14-15 ft. lbs. of

torque (Once set screws contact the tube,

tighten screws one full turn).

IMPORTANT: CHECK EACH CABLE, MAKING

SURE BOTH ARE SEATED PROPERLY ON

THE CABLE DRUMS AND HAVE EQUAL

CABLE TENSION.

Securing Door

for Spring Winding

(2) Vice Clamps

TRACK

VICE CLAMPS

ATTACHED TO

INNER RAIL

OF TRACK

Place vice clamps onto both vertical

tracks just above the third roller. This is

to prevent the garage door from raising

while winding torsion springs.

FAILURE TO PLACE VICE CLAMPS

ONTO VERTICAL TRACK CAN

ALLOW DOOR TO RAISE AND

CAUSE SEVERE OR FATAL INJURY

WARNING

PLACE VICE CLAMPS ABOVE

3RD ROLLER ON BOTH

VERTICAL TRACKS

Left end bearing

bracket

Cable in

position

Set

screws

Vice grips

Torsion

tube

Jamb

Left cable

drum

Left cable drum

Cable

Cable hooked

in cable drum

Counterbalance

cable

Counterbalance

cable

ManualsOcean

Info