User Manual Wayne-Dalton Backyard Playset 8850 [9/27 Pages]

Wayne-Dalton backyard playset 8850

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com

Tools Needed:

INSTALLATION

Attaching Bracket Mount Track &

Bottom Section

None

IMPORTANT: THE TOPS OF THE VERTICAL

TRACKS MUST BE LEVEL FROM SIDE

TO SIDE. IF THE BOTTOM SECTION WAS

SHIMMED TO LEVEL IT, THE VERTICAL

TRACK ON THE SHIMMED SIDE MUST BE

RAISED THE HEIGHT OF THE SHIM.

Position the left hand vertical track

assembly over the rollers of the bottom

section. Make sure the counterbalance

cable is located between the rollers and

the door jamb. Drill 3/16” pilot holes into

the door jamb for the lag screws.

Loosely fasten vertical track assembly

to the jamb using 5/16” x 1-5/8” lag

screws. Tighten the bottom lag screw to

jamb, to maintain 3/8” to 5/8” spacing as

shown between the bottom section and

vertical track. The other lag screws will be

tightened in step, Top Section.

Repeat for other side.

Stack the bottom section into position by

hooking the left hand roller into the left

hand vertical track, as shown in FIG. 1.

NOTE: Adjust the spacing of the vertical

tracks from 3/8” - 5/8” spacing at the

bottom section and 1-11/16” to 1-3/4”

spacing at the top section.

NOTE: Hang the counterbalance cables

over the top of the ﬂagangles as shown.

FIG 1

STACK THE SECTION

INTO POSITION, BY

HOOKING THE LEFT

HAND ROLLER INTO

THE VERTICAL TRACK

AND REPEATING FOR

THE RIGHT HAND SIDE.

FIG 1

WOOD JAMB

COUNTERBALANCE

CABLE

ManualsOcean

Info