User Manual Wowwee Toys 8405 Roborover [11/60 Pages]

WowWee toys 8405 RoboRover

Modes

Roborover has several different function modes and games

Explore Mode

In Explore Mode, Roborover can explore around his environment without your

commands; he can detect and avoid obstacles as he goes, and make comments

To enter Explore Mode, press the Explore button on the remote controller After approximately

3 minutes, he will exit Explore Mode and enter Standby Mode (refer to page 12 for

details) To exit Explore Mode before this, press the Stop button on the remote controller

Lookout Mode

In Lookout Mode, Roborover will scan his immediate environment in front of and behind

him He can then sound an alarm if he detects movement or a change to the environment

NOTE: You cannot give Roborover drive commands while he is in Lookout Mode

To activate Lookout Mode, do the following:

Press the 1 Lookout button on the remote controller Roborover will make a comment

Press the 2 Lookout button again

When he rst enters 3 Lookout Mode he will perform a long range scan of his

immediate environment in front of, and behind him This is approximately

12-18 m depending on the environment If there are objects nearby he will

perform a short range scan, this is approximately 30 cm

When Roborover detects any movements or new objects, he will sound an alarm 4

If Roborover detects something, he will remain in 5 Lookout Mode If he does not

detect anything for about 10 minutes he will exit Lookout Mode and wait for

a command If you do not enter a command within 2 minutes, he will enter

Standby Mode (refer to page 12 for details) To exit Lookout Mode before the

10 minutes is over, press the Stop button on the remote controller When he

exits Lookout Mode, he will tell you if he saw anything