User Manual Star Trac Home Gym E-Tbt [12/30 Pages]

Star Trac home gym E-TBT

12 STAR TRAC E SERIES TOTAL BODY TRAINERS OWNER’S MANUAL

Remove the (2) M4 x 0.7 screws from the display back (retain for later use) with a

#2 Phillips screwdriver and separate the back of the display from the front. .

Slide the back of the display with the mounting bracket onto the upper neck of the

Total Body Trainer. Line up all four holes and secure with (4) M6 x 50mm Socket

Head Cap Screws and (4) M6 Washers. Tighten down with the 5mm hex key.

Tighten to 240 lb-in (27 N-m).

Plug in the 12 pin display cable from the neck into the front display circut board at

J4. Next plug in the Heart Rate cable from the handlebars into the HR board, then

plug the HR ground into the quick disconnect tab on the diplay frame.

NOTE: If you are installing Entertainment, Refer to the PVS Install guide before this

step.

If you are not installing Entertainment, take Coax and DC power and return them

down the neck.

Slide the bottom of the front display under the 2 tabs at the base the the mount.

Press display against the round bar and rotate it to the back. Be careful not to

pinch any wires.

Secure the Front display to the back with (8) M4 x 0.7 x 19mm long Phillips Head

Screws. DO NOT overtighten.

3. Install the Upper Body Arms

Locate left side upper body arm, move to left side of the Total Bodt Trainer. Locate

hub. NOTE: One of the holes on the hub has no threads, this is clocking hole for

the pin on the upper body arm.

M4 x 0.7

Heart

Rate

Board

Ground

Wire

Quick

Disconnect

M6 x 50mm

Washers

M4 x 0.7

HUB

UPPER BOD

ARM

ManualsOcean

Info

Star Trac home gym 7700

Star Trac home gym 7600

Star Trac home gym ip-l8505

Star Trac home gym Inner/Outer Thigh Machine

Star Trac home gym Shoulder Press

Star Trac home gym Pro Recumbent Bike

Star Trac home gym IP-S1315

Star Trac home gym Pro Upright Bike

Star Trac home gym Olympic Bench

ManualsOcean

Info