Black Box computer hardware LEH1104A-4MMST Manual

PDF Manuals
208 Pages English

Black Box computer hardware LEH1104A-4MMST
724-746-5500 | blackbox.com
Page 122
Chapter 7: Command-Line Management
<1–65535> The loopback detect interval time in seconds.
4. Example:
The following example sets loopback detect interval time 10 seconds for bridge GROUP (1):
switch_a(config)#bridge 1 loopback-detect interval 10
switch_a(config)#
Loopback Detect (Port Interface):
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use this command to enable loopback detect for port interface.
Use the no parameter with this command to disable loopback detect for port interface.
3. Command Syntax:
loopback-detect port enable
no loopback-detect port enable
4. Example:
The following example enables loopback detect for port fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#loopback-detect port enable
switch_a(config-if)#
Static MAC Entry
Static-MAC-Entry Forward:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to statically configure a bridge entry to forward matching frames.
Related Manuals for Black Box computer hardware LEH1104A-4MMST