Black Box computer hardware LEH1104A-4MMST Manual

PDF Manuals
208 Pages English

Black Box computer hardware LEH1104A-4MMST
724-746-5500 | blackbox.com
Page 133
Chapter 7: Command-Line Management
4. Example:
The following example sets the LACP port priority 34 of interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#lacp port-priority 34
switch_a(config-if)#
LACP Timeout:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use lacp timeout command to set the short or long timeout on a port. The default is long timeout
3. Command Syntax:
lacp timeout short | long
timeout Number of seconds before invalidating a received LACP data unit (DU).
short LACP short timeout. Short timeout value is 3 seconds.
long LACP long timeout. Long timeout value is 90 seconds.
4. Example:
The following example sets the LACP short timeout on interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#lacp timeout short
switch_a(config-if)#
LACP System Priority:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use lacp system-priority command to set the system priority of a local system. This is used in determining the system responsible
for resolving conflicts in the choice of aggregation groups. Note: Lower numerical values have higher priorities.
Use no lacp system-priority command to reset the system priority of the local system to the default value (32768).
3. Command Syntax:
lacp system-priority <1-65535>
Related Manuals for Black Box computer hardware LEH1104A-4MMST